Kelly Industries Motor Board


Out of stock



Simplify your flywheel mod by using this simple PCB.  It makes soldering motors in place a snap.  Simply lay down the included plastic insulation sheet, line up the board as specified on the side of the board, and flood the motor tab areas with solder. New version can accept a 90 degree XT 60 connector (sold separately, available from us soon). We recommend flooding the entire middle +/- pads with solder so it is easier to solder your loom onto the board as pictured:

(old version of board)

Blasters should be modified at your own risk by an adult or with adult supervision. Modification of blasters may increase wear and reduce lifespan of blaster. Always wear eye protection. Never point at someone’s face. By purchasing, you agree that FoamBlast is not responsible for injury or damage caused by misuse or accidental usage.


Additional information

Weight .2 oz
Dimensions 60 × 25 × 3 mm


There are no reviews yet.

Be the first to review “Kelly Industries Motor Board”

Your email address will not be published. Required fields are marked *